CANON BCI-10 & BCI-11

CANON BCI-10 & BCI-11
Also Apple M3912GA, and M3910GA Cartridges.
Canon BJC 30 and BJC 70 Series Printers
as well as Apple Stylewriter 2200 Portable Printers.

1. Peel back the label to reveal the vent holes.
2. Insert the syringe through the vent hole, and push into the center of the cartridge. The cartridge contains sponge and a slight resistance will be felt.
3. Slowly inject up to 5ml. of ink for black ink or 3 ml. of color ink for each color or until ink appears at the filling hole.

OR

1. Flip over the cartridge. Locate the sponge(s) on the bottom.
2. Inject the cartridge with about 2 cc of ink Be careful -- this sponge doesn't hold much ink!
Inject S-L-O-W-L-Y to fill the entire cartridge. Be sure to remove and re-insert the needle a few times to expose the entire sponge to the ink.

Note - Set on a paper towel for an hour as a drip precaution. Expect a few drips. Cover all holes during storage to prevent leaks and evaporation.

Unused ink may be returned to the bottle.

Replace the cartridge and run a priming cycle as per printer instructions.