Canon Cartridge PG-40 (#40) and PG-50 (#50)

Refill Instructions
for Black cartridge

Instructions

1. Put the cartridge on some paper towels in an area where you can
tolerate a spill.

2. Drill a hole into the dimple just below the
"B".

3. Fill the syringe with
20 ml. of black ink.

4. Very S-L-O-W-L-Y inject ink into
the drilled hole.

5. When finished, you can put a
small piece of tape over the drilled hole, but this is not necessary.

6. Replace the cartridge and run 1 - 3 cleaning cycles as
per printer instructions.


For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge.

Note: Each time the cartridge is removed
from the printer an "empty cartridge" message appears and a blinking amber
light will come on, on the printer. Holding the paper feed button down for
3-5 sec. will allow you to override the counter.